If you have any problems with the registration process or your account login, please contact us. Registration is fast, simple and absolutely free so please, join our community today! By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. This problem did not occur in early 5.12 versions. net environment supports baudrate up to 65536 only because we dont need to set the real baudrate for an virtual COM port. So in this case, the baudrate is set back to 115200 and then everything works. If you are looking for information about Qt related issue - register and post your question. With sufficiently high baud rates (> 115200) it appears that the synchronous functions will stall. Since the laptop is connected with a real COM port, the baudrate has to be exact same with the hardware. Over 90 percent of questions asked here gets answered. Qt Centre is a community site devoted to programming in C++ using the Qt framework. Select the forum that you want to visit from the selection below. QSerialPort::Baud115200, 115200, 115200 baud. This enum describes the baud rate which the communication device operates with. So, you need to pass both properties: as a bauds and as a parities to parse an each of received package to validity. However, as written above, I am currently only up to 600,000 baud.Before you can post: click the register link above to proceed. This enum describes the baud rate which the communication device operates with. It is not an simple issue (IMHO), because in addition of different baud rates, the remote sensor can communicate with the different parity settings too. I know the Arduino cannot transmit at 3,000,000 baud, but 1,000,000 should be possible. But first I want to try using the Arduino at a higher baud rate. The actual hardware I want to connect is a sensor where the packet size is approximately 2600 bytes. I am currently trying some things with an Arduino DUE, there the packet size I send is 4Byte. I am currently using QT 5.12.4 on a Windows 10 system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |